Motherboard form factors
Three board sizes; the case must take the board
ATX, microATX, Mini-ITX. Smaller board, fewer slots.
A motherboard comes in standard sizes, so that it fits standard cases. These three are drawn to scale. A T X is the full-size desktop board, with room for up to seven expansion cards. Micro A T X is the same width but shorter, with up to four. Mini I T X is a small square, with a single slot. A big case usually takes the smaller boards as well.
Motherboard form factors · Going deeper
What plugs in where
PCIe, M.2, SATA, headers, 24-pin power.
Processors
Cores do the work; threads let each core hold two jobs
8 cores, 16 threads with multithreading.
A processor is described by how much it can do at once. A single core runs one job at a time, and switches between them quickly. A multicore processor has several cores on one chip. This one has eight, so eight jobs truly run together. With multithreading, each core presents two threads to the operating system. Eight cores, sixteen threads. The two threads share a core, so it is a gain, but not double.
Processors · Going deeper
Architecture, sockets and virtualization
x64 on PCs, ARM on phones. The socket must match.
Check yourself
Which board fits this build?
BIOS and UEFI
Firmware settings decide what may start
Boot order, Secure Boot, TPM, and two passwords.
Before the operating system loads, the firmware on the board is in charge. At power on, U E F I tests the hardware. If a boot password is set, it asks for it now. Then it follows the boot order, and takes the first device that can start. Secure Boot checks that the loader on that device is signed by a key it trusts. And the T P M, a security chip on the board, hands over the disk encryption key only if nothing was tampered with.
BIOS and UEFI · Going deeper
UEFI settings, TPM and HSM
BIOS password guards settings. HSM guards keys for many.
Power supplies
Add up what the parts draw, then leave headroom
505 W of parts on a 750 W supply.
A power supply is chosen by adding up the parts. This bar is the supply's full rating, seven hundred and fifty watts. The video card takes the most. Then the processor. The board and memory. The drives. And the fans. Together that is 505 watts, about two thirds of the rating. The gap is headroom. It keeps the supply cool and quiet, and leaves room for an upgrade.
Power supplies · Going deeper
Voltages, connectors and types of supply
3.3 V, 5 V, 12 V. Modular and redundant.
Check yourself
Which power supply should go in?
Cooling
Heat leaves in a chain; a break anywhere overheats the chip
Paste, heat sink, fan, airflow.
Everything a processor does turns into heat, and that heat has to leave. It starts in the processor. Thermal paste fills the microscopic gaps between the chip and the metal above it. The heat sink spreads the heat through its fins. A fan pushes air across them. And the case moves that warm air out. Liquid cooling does the same job with a pump and a radiator.
Cooling · Going deeper
Expansion cards and cooling parts
Video, sound, capture and network cards.
Check yourself
What should the technician do first?
Lesson complete
You finished “Motherboards, processors and power”
Answer the questions along the way to see your score here.